HDO4000 Datasheet, PDF (13/16 Pages) Teledyne Technologies Incorporated – High Definition Oscilloscopes

probes
The right probe is an essential tool for accurate signal capture and Teledyne LeCroy offers an extensive range of
probes to meet virtually every probing need.
ZS Series High Impedance
Active Probes
ZS2500, ZS1500, ZS1000,
ZS2500-QUADPAK,
ZS1500-QUADPAK,
ZS1000-QUADPAK
The ZS Series probes provide high impedance and an
extensive set of probe tips and ground accessories to
handle a wide range of probing scenarios. The high
1 MΩ input resistance and low 0.9 pF input capacitance
mean this probe is ideal for all frequencies. The ZS Series
probes provide full system bandwidth for all Teledyne
LeCroy oscilloscopes having bandwidths of 1 GHz
and lower.
Differential Probes
(200 MHz – 1.5 GHz)
ZD1500, ZD1000, ZD500,
ZD200
High Voltage
Differential Probes
ADP305, ADP300, AP031
High bandwidth, excellent common-mode rejection ratio
(CMRR) and low noise make these ­active differential
probes ideal for applications such as automotive
development (e.g. FlexRay) and failure analysis, as well
as wireless and data communication design. The ProBus
interface ­allows sensitivity, offset and common-mode
range to be displayed on the oscilloscope screen.
Low cost active differential probes are intended for
measuring higher voltages. The ­differential techniques
employed permit measurements to be taken at two
points in a circuit without reference to the ground,
allowing the oscilloscope to be safely grounded without
the use of opto-isolators or isolating transformers.
High Voltage
Passive Probes
PPE1.2KV, PPE20KV,
PPE2KV, PPE4KV, PPE5KV,
PPE6KV
Current Probes
CP031, CP030, AP015,
CP150, CP500, DCS015
The PPE Series includes five fixed-attenuation probes
covering a range from 2 kV to 20 kV, and one switchable
probe providing ÷10/÷100 attenuation for voltage inputs
up to 1.2 kV. All fixed-attenuation, standard probes
automatically rescale compatible Teledyne LeCroy
oscilloscopes for the ­appropriate attenuation of the probe.
Available current probes reach bandwidths of 100 MHz,
peak currents of 700 A and ­sensitivities of 10 mA/div. Use
multiple current probes to make measurements on three-
phase systems or a single current probe with a voltage
probe to make instantaneous power measurements.
Teledyne LeCroy current probes enable the design and
testing of switching power supplies, motor drives, electric
vehicles, and uninterruptible power supplies.
13