409-32041 Datasheet, PDF (9/9 Pages) TE Connectivity Ltd – 12 Ton Pistol Grip

409-32041
7. SPARE PARTS
 Battery: 2280309-1
 Charger: 2217331-1 (120 V, US), 2217331-2 (220 V EU)
8. TROUBLESHOOTING
See Figure 5.
Prior to beginning troubleshooting procedures, be sure the battery is operational.
1. Be sure that the battery is charged. Recheck the battery after several minutes to ensure that the
battery is holding its charge.
2. Use a nonflammable contact cleaner or pencil eraser to clean the electrical contacts on the battery
and crimp tool.
3. Reinstall the battery and check the crimp tool again.
PROBLEM
Tool is inoperative.
Dies stop during operation.
Crimp tool loses oil.
PROBABLE CAUSE
Dirt, contaminants, etc., in ram area of tool.
Crimp tool battery contacts damaged.
Tool components worn or damaged.
Oil level is low.
Air is in the hydraulic system.
There is damage to the internal seal.
REMEDY
Clean the tool.
Reform the contacts.
Return tool to TE.
Return tool to TE.
Pull the trigger and hold the retract button
simultaneously. Hold for about 10 seconds.
Return tool to TE.
9. DECOMMISSIONING
Figure 5
In compliance with the regulations in force in the country where the tool is used, the user must make sure that
waste produced during operation is correctly disposed. Disposal of lubricants and parts removed must be
carried out in compliance with the standards in force in the country where the tool is used.
10. RETURN
Order replacement parts through your TE Representative, or call 1.800.526.5142; or send a facsimile of your
purchase order to 1.717.986.7605; or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1.800.526.5136.
11. RoHS INFORMATION
Information on the presence and location of any substances subject to RoHS (Restriction on Hazardous
Substances) can be found at the following website:
http://www.te.com/en/resources/product-compliance.html
Click on “Check Product Compliance and Get Statements of Compliance (SoC)” and then click on “Check
Product Compliance Search Tool.”
12. REVISION SUMMARY
 Deleted or changed text in Steps 4, 6, CAUTION, and Step 8 of Paragraph 5.2 and renumbered.
Rev B
9 of 9