409-32041 Datasheet, PDF (5/9 Pages) TE Connectivity Ltd – 12 Ton Pistol Grip

409-32041
When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.
DANGER
Denotes an imminent hazard that may result in moderate or severe injury.
CAUTION
Denotes a condition that may result in product or equipment damage.
NOTE
Highlights special or important information.
NOTE
Dimensions in this customer manual are in metric units [with U.S. customary units in brackets]. Figures are not drawn to scale.
2. RECEIVING/INSPECTION
The 12 Ton Pistol Grip Battery Powered Crimp Tool Kit 2280308-[ ] is thoroughly inspected during and after
assembly. Prior to packaging and shipping, a final series of tests and inspections is made to ensure proper
functioning of the tool. The following inspection should be performed as a safeguard against potential problems
generated in transit.
1. In a well-lighted area, carefully uncrate the tool and inspect each component as it is removed from the
crate.
2. Thoroughly inspect each component for evidence of damage that may have occurred in transit. If any
of the components are damaged, file a claim against the carrier and notify TE Connectivity
immediately.
3. Keep this manual and all drawings and product samples with the tool for the benefit of operation and
maintenance personnel.
The crimp tool should be inspected at regularly scheduled intervals, depending on card, degree of operator
skill, the type and size of product being crimped, and environmental conditions. At a minimum, the tool should
be inspected after every 40 hours of use.
3. INSTALLATION/REMOVAL OF DIE ASSEMBLIES
CAUTION
Do not operate the tool without the Latch Head installed. Damage to the ram or seals can result.
CAUTION
Do not operate the tool without the die assemblies. Damage to the crimp head can result.
The 12 Ton Battery Powered Crimp Tool 2280308-[ ] comes with the crimp head already installed on the
battery-powered hand tool. The only installation required is the installation of the die assemblies.
DANGER
To avoid personal injury, be sure to exercise extreme caution when handling the crimp tool. Avoid accidentally depressing the
trigger control when installing or removing crimp dies.
3.1. Installation of Die Assemblies
Refer to Figure 2.
CAUTION
These instructions are specific to the use of TE die assemblies. Be sure to use ONLY TE die assemblies.
1. Remove the battery from the tool.
2. Press button and insert die into the ram. Dies will “click” into position.
3. Press button and insert the stationary die into the yoke. Die will “click” into position.
Rev B
5 of 9