108-115008 Datasheet, PDF (8/8 Pages) TE Connectivity Ltd – Shield Finger Scalable Height From 1.24mm to 3.4mm

The applicable products description and part numbers are as shown in appendix 1.
Part Number
1551631-4
1551572-4
1551573-4
1551574-4
1551575-4
1551576-4
Description
Spring Finger 124
Spring Finger 1.80
Spring Finger 2.15
Spring Finger 2.60
Spring Finger 3.0
Spring Finger 3.4
Qualification Test
501-115009
501-115009-1
501-115009-2
501-115009-3
501-115009-4
501-115009-5
Appendix 1
4. QUALITY ASSURANCE PROVISIONS
4.1. Qualification Testing
A. Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of a minimum of 5
specimens.
B. Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 1.
4.2. Requalification Testing
If changes significantly affect form, fit or functions are made to the product or manufacturing
process, product assurance shall coordinate requalification testing, consisting of all or part of
the original testing sequence as determined by development/product, quality and reliability
engineering.
4.3. Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1.
Failures attributed to equipment, test setup or operator deficiencies shall not disqualify the
product. If product failure occurs, corrective action shall be taken and specimens resubmitted
for qualification. Testing to confirm corrective action is required before resubmittal.
4.4. Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be
used. Dimensional and functional requirements shall be in accordance with the applicable
product drawing and this specification.
PAGE NO
TE Connectivity (Shanghai)
8/8
ASHL-0005- ES REV A
108-115008
REV LOC
A2 _ES