408-10050 Datasheet, PDF (5/8 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY

408-10050
5.1. Crimp Inspection (Figure 4)
NOTE
The accompanying procedure is included as an aid to the local operator ONLY. It is not intended to
serve as a quality control procedure for qualifying finished crimps on SOLISTRAND terminals or
splices.
Inspect crimped terminals or splices by checking the features described in Figure 4. USE ONLY terminals or
splices that meet the conditions shown in the ACCEPT column. Terminals and splices displaying the features
shown in the REJECT column can be avoided by careful use of these instructions and by performing the
maintenance and inspection procedures described in paragraphs 5.2. and 5.3.
Rev D
Figure 4
5 of 8