408-10050 Datasheet, PDF (2/8 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY

408-10050
3. DIE INSTALLATION AND REMOVAL
Refer to Table 1 and determine the correct die assembly and wire size for the terminal splice part number.
DANGER
Avoid personal injury. Exercise extreme caution when using the tool.
3.1. Die Installation
1. Pivot the latch arm away from the yoke to open the crimp head.
2. Loosen the set screw in the yoke.
3. Insert the shank of the nest into the yoke and tighten the set screw.
4. Extend the ram until the set screw is visible.
5. Loosen the set screw in the ram.
6. Insert the shank of the indenter into the ram and tighten the set screw.
7. Return the ram to the down position.
8. Pivot the latch arm and yoke toward each other until the locking flange secures the latch arm to the
yoke.
CAUTION
Always make sure the yoke and latching arm are secured by the locking flange before cycling the tool.
Nominal Wire Size
mm2
Typical
Mm² AWG (Circular Mil Area Range) Product
Dies
Nest
Indenter
7-8
8
6.637-10.539
[13,100-20,800]
33463
RTT⁽³⁾
1901001-1⁽²⁾ 1901002-2⁽²⁾
13-15
6
10.539-16.771
[20,800-33,100]
33466
RTT⁽³⁾
1901000-1⁽²⁾ 1901002-1⁽²⁾
21
4⁽¹⁾
16.771-26.653
[33,100-52,600]
34323
BS⁽⁴⁾
1901000-2⁽²⁾ 1901002-1⁽²⁾
(1) STRATO-THERM 4 AWG can only be crimped with 2217330-[ ] Revision G or higher
(2) Also used for STRATO-THERM* Heat Resistant Uninsulated Terminals
(3) RTT = Ring Tongue Terminals
(4) BS = Butt Splice
Table 1
3.2. Die Removal
1. Pivot the latch arm away from the yoke to open the head.
2. Loosen the set screw in the yoke and remove the nest.
3. Raise the ram to full up position.
4. Loosen the set screw in the ram and remove the indenter.
Rev D
2 of 8