408-10050 Datasheet, PDF(1/8 Page) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

408-10050 Datasheet, PDF (1/8 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY

Crimping Dies Tool PN 2217330 for

SOLISTRAND* Terminals and Splices

Instruction Sheet

408-10050

31 AUG 16 Rev D

Figure 1

1. INTRODUCTION

This instruction sheet provides instruction on application, maintenance and inspection procedures for dies that

crimp SOLISTRAND ring tongue terminals, butt splices and parallel splices. These dies are used to crimp

product on solid or stranded copper wire. The dies are used in Battery Operated Hand Tool PNâs 1901343-1, -

2, -3, -4 and 2217330-1, -2 and -5 (Customer Manual 409-10070). Read these instructions and all applicable

references before inserting any die assemblies and crimping any terminals. See Table 1

Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY.

NOTE

Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Illustrations are for reference only and not

drawn to scale.

2. DESCRIPTION

Each die assembly consists of a nest and an indenter, ordered separately, which are retained in the crimping

head by set screws. The nest is positioned in the yoke of the crimping head and the indenter is positioned in

the ram of the tool, in all applications.

*Trademark

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com.

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.

1 of 8

▷