108-19376 Datasheet, PDF (4/13 Pages) TE Connectivity Ltd – This specification covers the performance, test and quality requirements for the Tyco Electronics High Speed 8 pairs IO board and cable connector.

108-19376
MECHANICAL
Para Test Description
Performance
Requirements or Severity
3.4.10 Signal Contact spring Min. 0,5N
force
3.4.11 Shielding Contact
spring force
Min. 2,5N
Procedures
At deflection of 0.165
mm.
At deflection: till Board
connector shield
(outside springs on
BCv1)
3.4.12 Shielding Contact
spring force
Min. 2,5N at A=0,25mm
(see figure 3)
(outside springs on
BCv2)
3.4.13 Shielding Contact
spring force
Min. 1,0N at B=0,25mm
(see figure 4)
(inside-bended springs
on board connector
version 2)
3.4.14 Vibration
10-500 Hz sweeping
1 oct./min., displacement 0,75mm peak/accel. 10
g , 30 minutes in each of 3 mutual perpendicular
axes.
At required deflection
to reach dimension A
(see figure 3).
Maximum deflection
to be applied:
A=0,15mm.
At required deflection
to reach dimension B
(see figure 5).
Maximum deflection
to be applied:
B=0,15mm.
In acc. with
IEC 60068-2-6
3.4.15 Physical shock
3.4.16 Insertion-force during
wrong polarization.
Requirement:
No Physical damage.
No discontinuity > 1 µsec.
Subject connector to 50 g half sine shock pulses of
11 ms duration.
6 shocks in two directions of 3 mutual
perpendicular axes.
Apply 100 N straight force at the cable connector
(placed upside down) in mating direction during 10
sec.
In acc. with
IEC 60512-6-3
In acc. with
IEC 60512-15-1
3.4.17 Mate / un-mate force
without latch.
Requirement:
No functional damaging and no electrical
contacting on signal-traces.
Mate and un-mate connector-pair.
Speed: 2 mm/sec. rest 30 sec min.
In acc. with
IEC 60512-13-2
3.4.18 Mechanical operation
(Inclusive latch)
Requirement:
Total mating force 50 N max.
Total un-mating force 10 N min to 40 N max.
Mate and un-mate specimens for 100 cycles at a
maximum rate of 500 cycles per hour with cage
latch operable at room conditions.
In acc. With
IEC 60512-9-1
Rev. D
R6-77 (Rev. 03-00)
Page 4 of 13