108-19376 Datasheet, PDF (1/13 Pages) TE Connectivity Ltd – This specification covers the performance, test and quality requirements for the Tyco Electronics High Speed 8 pairs IO board and cable connector.

Product
Specification
108 – 19376
Rev.D 10/sep/2012
1 SCOPE
1.1 Content
This specification covers the performance, test and quality requirements for the Tyco Electronics High
Speed 8 pairs IO board and cable connector. The cable plug assembly is used to connect the cable to the
board connector.
1.2 Qualification
When tests are performed on subject product, procedures specified in this Product Specification shall be
used. All inspections shall be performed using applicable inspection plan and product drawing.
1.3 Applicable partnumbers
The partnumbers of subject products:
• X-2042847-x
HSIO Cable Plug Assembly
• X-2042853-x
HSIO Board Connector Assembly, version 1 (referred to as BCv1)
• X-1551966-x
HSIO Board Connector Assembly, version 2 (referred to as BCv2)
1.4 Completion
Qualification testing of the HSIO Board Connector Assembly version 1 has successfully been completed
on 20JUL2011 and is reported in Qualification Test Report with number 501-19154. This documentation
is on file and available from Engineering Practices and Standards (EPS).
Qualification testing of HSIO Board Connector Assembly version 2 is yet to be completed.
2 Applicable Documents
The following documents form a part of this specification to extend specified herein. Unless otherwise
specified, latest edition of the document applies. In the event of conflict between the requirements in this
specification and the product drawing, product drawing shall take precedence. In the event of conflict
between requirements of this specification and referenced documents, this specification shall take
precedence.
2.1 Tyco Documents
501-19154
Test report. Cable/Board High Speed Connector assembly (version 1).
114-19129
Application specification High Speed Cable/Board Connector System.
2.2 Other Documents
IEC 60512
Basic testing procedures and measuring methods for electromechanical components
for electronic equipment.
J. Smits
DATE 10 sep 2012
T de Boer
DATE 10 sep 2012
Tyco Electronics Nederland B.V.
All international rights reserved
TE Connectivity
*Trademark
R6-76 (Rev. 03-00)
This information is confidential and propriety to TE
Connectivity and its worldwide subsidiaries and affiliates.
It may not be disclosed to anyone, other than TE
Connectivity personnel, without written authorization from
TE Connectivity Corporation, Harisburg, Pennsylvania USA
This specification is a controlled document and subject to
change. Contact the Engineering Control Organization for
the latest revision.
1 of 13
LOC H