108-19376 Datasheet, PDF (3/13 Pages) TE Connectivity Ltd – This specification covers the performance, test and quality requirements for the Tyco Electronics High Speed 8 pairs IO board and cable connector.

108-19376
3.4 Performance and Test Description.
The product is designed to meet mechanical and environmental performance specified in this paragraph
as tested per test sequence specified in paragraph 3.5.
Unless otherwise specified, all tests are performed at ambient environmental conditions per IEC
specification 60068-1 clause 5.3 and are performed with connectors in mated condition.
VISUAL
Para Test Description
Performance
Requirements or Severity
3.4.1. Examination of product Meets requirements of product
Drawing and applicable instructions on customer
drawing, instruction sheet, application
specification.
Procedures
Visual, dimensional
and
functional per
applicable
inspection plan.
ELECTRICAL
Para Test Description
Performance
Requirements or Severity
3.4.2 Termination resistance Max. open voltage 20mV.
Board connector – Max. current 100 mA DC.
Cable connector
All contacts to be measured.
(signal and ground) Measuring points shall be as indicated in fig.1
3.4.3
3.4.4
Requirement:
30 mΩ max. (Initial; exclusive bulk)
40 mΩ max. (Final; exclusive bulk)
Termination resistance Max. open voltage 20mV.
Board connector – Max. current 100 mA DC.
Cable connector
Measuring points shall be as indicated in fig 2.
(shield)
Requirement:
Initial: 10 mΩ max.
Final: 20 mΩ max.
Insulation resistance Test voltage 100V DC.
Duration: 1 minute.
Test between adjacent contacts.
3.4.5 Voltage proof
Requirement:
10³ MΩ min.
Test voltage 300 VDC for adjacent contacts.
Duration 1 minute.
Requirement: no break-down or flash-over
Procedures
In acc. With
IEC 60512-2-1
In acc. With
IEC 60512-2-1
In acc. with
IEC 60512-3-1
In acc. with
IEC 60512-4-1
3.4.6 Current temperature Temperature rise: 30°C maximum over ambient
de-rating curve
temperature (65°C) at 0,5 A
In acc. with
IEC 60512-5-2 / test
5b
Rev. D
R6-77 (Rev. 03-00)
Page 3 of 13