408-9393 Datasheet, PDF (2/6 Pages) TE Connectivity Ltd – Pneumatic Power

408-9393
Figure 1
DANGER
This unit should only be operated by trained personnel.
DANGER
This tool is not insulated for coming into contact with electric power sources.
DANGER
Do not use this tool in explosive atmospheres.
DANGER
Stored gas or fluid energy may cause a hazard.
1. INTRODUCTION
Pneumatic Power Bench Assembly 58338-1 is a pneumatic power unit designed to accept a variety of
interchangeable terminating heads or feed track assemblies that terminate unstripped wire in connectors.
Refer to the instructions packaged with the terminating head or feed track assembly for proper selection, setup
and adjustment procedures, terminating and test procedures, and maintenance. Read this and all referenced
materials carefully before using the power bench assembly.
NOTE
Dimensions in this instruction sheet are in metric units [with U.S. customary units in brackets].
Figures are for reference only and are not drawn to scale.
Reasons for reissue of this instruction sheet are provided in Section 9, REVISION SUMMARY.
2. DESCRIPTION (SEE FIGURE 2)
The power bench assembly consists of a bench mount with an attached pneumatic power assembly, a foot
switch, and air tubes which connect the foot switch to the power assembly and the air source to the foot switch.
The bench mount is attached to a bench or work table with screws or clamps and the foot switch is used to
actuate the power assembly when connected to an air source.
In this use, the pneumatic power bench assembly emits a noise level less than 70 dB and the vibration level is
less than 2.5 mm/s².
Rev F
2 of 6