408-1602 Datasheet, PDF (10/11 Pages) TE Connectivity Ltd – For information on tool setup and operation, refer to Instruction Sheet

408-1602
Figure 10
Die Assembly
46754-2
46755-2
46756-2
46757-2
46758-2
Gage Element Diameter
GO
NO-GO
13.564-13.571
13.815-13.818
[.5340-.5343]
[.5439-.5440]
15.037-15.044
15.288-15.291
[.5920-.5923]
[.6019-.6020]
16.612-16.619
16.863-16.866
[.6540-.6543]
[.6639-.6640]
17.831-17.838
18.082-18.085
[.7020-.7023]
[.7119-.7120]
19.406-19.413
19.657-19.660
[.7640-.7643]
[.7739-.7740]
Die Assembly
46759-2
46760-2
59870-1
69653
Gage Element Diameter
GO
NO-GO
20.422-20.429
20.673-20.676
[.8040-.8043]
[.8139-.8140]
21.539-21.547
21.791-21.793
[.8480-.8483]
[.8579-.8580]
18.288-18.296
18.539-18.542
[.7200-.7203]
[.7299-.7300]
12.421-12.428
12.672-12.675
[.4890-.4893]
[.4989-.4990]
Figure 11
If the crimping chamber DOES conform to the gage inspection, the dies may be considered dimensionally
correct and should be lubricated with a THIN coat of any good SAE 20 motor oil.
If the crimping chamber DOES NOT conform to the gage inspection, refer to Section 7 for information on
obtaining further evaluation and repair.
NOTE: For additional information regarding the use of a plug gage, reference Instruction Sheet 408-7424.
Rev C
10 of 11