408-1602 Datasheet, PDF (1/11 Pages) TE Connectivity Ltd – For information on tool setup and operation, refer to Instruction Sheet

Crimping Die Assemblies 46754-2,
46755-2, 46756-2, 46757-2, 46758-2,
46759-2, 46760-2, 59870-1, and 69653
Instruction Sheet
408-1602
10 NOV 16 Rev C
WIRE SIZE
(MCM)⁽¹⁾
CMA
(Circular Mil Area)
Range
Die Assembly PN
Single Crimp Dual Crimp
350
350 HD
325,000-375,000
69653
---
400
375,000-450,000 46754-2
---
500
500
450,000-550,000
46755-2
---
---
46756-2⁽²⁾
600
600 HD
550,000-650,000
---
46756-2
59870-1
700
650,000-750,000
---
46757-2
800
750,000-850,000
---
46758-2
900
850,000-950,000
---
46759-2
1000 950,000-1,125,000
---
46760-2
1 _{MCM equals thousand circular mils}
2 _{After crimping, product insulation will be embossed with 600}
Figure 1
1. INTRODUCTION
AMP* crimping die assemblies listed in Figure 1 are designed to crimp AMPOWER* terminals, parallel splices
and butt splices onto wire sizes 350 through 1000 MCM. The die assemblies are installed into Crimping Head
PN 69082 (Mod 1). The head is used with Hydraulic Power Units PN 69120-1 or 69120-2.
For information on tool setup and operation, refer to Instruction Sheet 408-2456 for the crimping head and
Customer Manual 409-1950 for the power units.
Read these instructions carefully prior to installing, removing or using the dies.
NOTE
Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures are not drawn to scale.
Reasons for re-issue of this instruction sheet are provided in Section 8, REVISION SUMMARY.
© 2016 TE Connectivity Ltd. family of companies.
All Rights Reserved.
*Trademark
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 11