C0402C0G1C220KT Datasheet, PDF (12/34 Pages) TDK Electronics – MULTILAYER CERAMIC CHIP CAPACITORS

(continued)
No.
17 Life
Item
Performance
External
No mechanical damage.
appearance
Capacitance
Characteristics
Change from the
value before test
Class1
CH
C0G
±3% or ±0.3pF,
whichever larger.
JB
X5R
*Class2
X6S
X7R
X7S
X7T
± 10 %
± 12.5 %
± 25 %
* Applied for some parts.
Q
(Class1)
Rated Capacitance
Q
30pF and over
10pF and over under
30pF
Under 10pF
350 min.
275+5/2×C min.
200+10×C min.
C : Rated capacitance (pF)
D.F.
(Class2)
200% of initial spec. max.
Insulation
Resistance
1,000MΩ or 50MΩ·μF min.
(As for the capacitors of rated
voltage 16, 10V DC and lower,
1,000 MΩ or 10MΩ·μF min.,)
whichever smaller.
Test or inspection method
Reflow solder the capacitors on a
P.C.Board shown in Appendix1a or
Appendix 1b before testing.
Below the voltage shall be applied at
maximum operating temperature ±2°C
for 1,000 +48, 0h.
Applied voltage
Rated voltage x2
Rated voltage x1.5
Rated voltage x1.2
Rated voltage x1
For information which product has
which applied voltage, please contact
with our sales representative.
Charge/discharge current shall not
exceed 50mA.
Leave the capacitors in ambient
condition for 6 to 24h (Class1) or
24±2h (Class2) before measurement.
Voltage conditioning (only for class 2)
Voltage treat the capacitors under
testing temperature and voltage for 1
hour.
Leave the capacitors in ambient
condition for 24±2h before
measurement.
Use this measurement for initial value.
*As for the initial measurement of capacitors (Class2) on number 8,12,13,14 and 15, leave capacitors at 150
-10,0°C for 1 hour and measure the value after leaving capacitors for 24 ± 2h in ambient condition.
— 11 —