STBP112 Datasheet, PDF (9/38 Pages) STMicroelectronics – Overvoltage protection device

STBP112
Figure 3. Block diagram
).
%3$
PROTECTION
#ORE
NEGATIVE
PROTECTION
3500,9
2%'5,!4/2
62%&
6##
6/,4!'%
2%&%2%.#%
Pin description
/3#),,!4/2
#(!2'%05-0
!.$-/3&%4$2)6%2
/&&
7)4(3/&434!24
#/5.4%23
/54
)NPUTOVERVOLTAGE
)NPUTUNDERVOLTAGE
4EMPERATURE ^{4HERMALSHUTDOWN}
DETECTOR
#/.42/,,/')#
&,4
-#5
).4%2&!#%
%.
20$%.
%3$
%3$
PROTECTION PROTECTION
'.$
Figure 4. Typical application circuit
!-6
!#
ADAPTER
3934%-
#/..%#4/2
/2
0/7%2%$
0%2)0(%2!,3
0%2)0(%2!,
3500,9#522%.4
#(!2').'#522%.4
# ^).
/54
#
—& 34"0 _—&
$# $#
%.
#(!2'%2
)#
"!44%29
0!#+
3500,9
#)2#5)43
%.!",%
205
&,4
%.
'.$
2&,4
2%.
#/.42/,,%2
!00,)#!4)/.
!-6
1. Optional resistors R_EN and R_FLT prevent damage to the controller under extreme voltage or current conditions and are not
required. Low ESR ceramic capacitor C1 is necessary to ensure proper function of the STBP112. Capacitor C2 is not
necessary for STBP112 but may be required by the charger IC.
2. The STBP112 MOSFET switch topology allows the current to flow also in a reverse direction, i.e. from OUT to IN, which
can be useful for powering external peripherals from the system connector. If the reverse current (supply current) is
undesirable, it may be prevented by connecting an external Schottky diode in series with the OUT pin. The voltage drop
between IN and the charger is then increased by the voltage drop across the diode.
Doc ID 023357 Rev 3
9/38