STM32F410X8 Datasheet, PDF (63/142 Pages) STMicroelectronics – Clock, reset and supply management

STM32F410x8/B
Electrical characteristics
Table 25. Typical and maximum current consumption in run mode, code with data processing
(ART accelerator disabled) running from Flash memory - V_DD = 3.6 V
PLL Typ
Max⁽²⁾
Symbol Parameter
Conditions
f_HCLK Voltage VCO
(MHz)
scale
(MHz)
(1)
T_A=
25 °C
T_A =
25 °C
T_A = T_A = T_A = ^Unit
85 °C 105 °C 125 °C
100
S1
200 24.7 26.3 26.5 27.0 28.0
84
External clock, ₆₄
all peripherals
enabled⁽³⁾⁽⁴⁾
50
25
S2
168 21.6 23.0 23.2 23.7 24.7
S3
128 15.9 17.0 17.1 17.6 18.6
S3
100 13.1 14.2 14.3 14.7 15.7
S3
100 7.5 8.2
8.3
8.7
9.7
20
S3
160 6.5 7.1
7.2
7.5
8.5
HSI, PLL OFF, 16
S3
off 4.7 5.3 5.5 5.9 6.9
all peripherals
Supply
enabled⁽³⁾⁽⁴⁾
1
S3
off 0.8 1.2
1.6
1.9
2.9
I_DD current in
Run mode
mA
100
S1
200 19.1 20.5 20.7 21.3 22.3
84
S2
168 17.1 18.3 18.6 19.1 20.1
External clock, ₆₄
all peripherals
disabled⁽³⁾
50
S3
128 12.8 13.8 14.0 14.5 15.5
S3
100 10.7 11.7 11.8 12.2 13.2
25
S3
100 6.3 7.0
7.1
7.4
8.3
20
S3
160 5.4 6.0
6.2
6.5
7.4
HSI, PLL OFF, 16
S3
off 4.0 4.5 5.0 5.1 6.0
all peripherals
disabled⁽³⁾
1
S3
off 0.8 1.1
1.5
1.8
2.7
1. Refer to Table 44 and RM0401 for the possible PLL VCO setting
2. Guaranteed by characterization, unless otherwise specified.
3. When the ADC is ON (ADON bit set in ADC_CR2), an additional power consumption of 1.6 mA must be added.
4. Add an additional power consumption of 1.6 mA per ADC for the analog part. In applications, this consumption occurs only
while the ADC is ON (ADON bit is set in the ADC_CR2 register)
DocID028094 Rev 5
63/142
118