RHF330 Datasheet, PDF (3/22 Pages) STMicroelectronics – Rad-hard 1 GHz low noise operational amplifier

RHF330
Absolute maximum ratings and operating conditions
1
Absolute maximum ratings and operating conditions
Table 2. Absolute maximum ratings
Symbol
Parameter
V_CC
V_id
V_in
T_stg
T_j
R_thja
R_thjc
P_max
ESD
Supply voltage⁽¹⁾
Differential input voltage⁽²⁾
Input voltage range⁽³⁾
Storage temperature
Maximum junction temperature
Flat-8 thermal resistance junction to ambient
Flat-8 thermal resistance junction to case
Flat-8 maximum power dissipation⁽⁴⁾
(T_amb = + 25° C) for T_j = 150° C
HBM: human body model⁽⁵⁾
pins 1, 4, 5, 6, 7 and 8
pins 2 and 3
MM: machine model⁽⁶⁾
pins 1, 4, 5, 6, 7 and 8
pins 2 and 3
CDM: charged device model⁽⁷⁾
pins 1, 4, 5, 6, 7 and 8
pins 2 and 3
Latch-up immunity
Value
6
± 0.5
± 2.5
-65 to +150
150
50
30
830
2
0.6
200
80
1.5
1
200
Unit
V
V
V
°C
°C
°C/W
°C/W
mW
kV
V
kV
mA
1. All voltage values are measured with respect to the ground pin.
2. Differential voltage is the non-inverting input terminal with respect to the inverting input terminal.
3. The magnitude of input and output voltage must never exceed V_CC +0.3 V.
4. Short-circuits can cause excessive heating. Destructive dissipation can result from short-circuits on all
amplifiers.
5. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
6. This is a minimum value.
Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
7. Charged device model: all pins and package are charged together to the specified voltage and then
discharged directly to ground through only one pin.
Table 3. Operating conditions
Symbol
Parameter
Value
Unit
V_CC Supply voltage
4.5 to 5.5
V
V_icm
T_amb
Common-mode input voltage
Operating free-air temperature range⁽¹⁾
-V_CC +1.5 to +V_CC-1.5
V
-55 to +125
°C
1. Tj must never exceed +150°C. P = (Tj - Tamb)/Rthja = (Tj - Tcase)/Rthjc with P being the power that the
RHF330 must dissipate in the application.
Doc ID 15576 Rev 3
3/22