M14C64 Datasheet, PDF (2/14 Pages) STMicroelectronics – Memory Card IC 64/32 Kbit Serial I²C Bus EEPROM

M14C64, M14C32
Figure 2. D20 Contact Connections
VCC
WC
SCL
GND
SDA
Figure 3. D22 Contact Connections
VCC
WC
SCL
GND
SDA
AI02168
AI02204
form only. For availability of the M14C64 in wafer
form, please contact your ST sales office.
Each memory is compatible with the I²C extended
memory standard. This is a two wire serial inter-
face that uses a bi-directional data bus and serial
clock. The memory carries a built-in 7-bit unique
Device Type Identifier code (1010000) in accord-
ance with the I²C bus definition. Only one memory
can be attached to each I²C bus.
The memory behaves as a slave device in the I²C
protocol, with all memory operations synchronized
by the serial clock. Read and write operations are
initiated by a START condition, generated by the
bus master. The START condition is followed by
the Device Select Code which is composed of a
stream of 7 bits (1010000), plus one read/write bit
(R/W) and is terminated by an acknowledge bit.
When writing data to the memory, the memory in-
serts an acknowledge bit during the 9^th bit time,
following the bus master’s 8-bit transmission.
When data is read by the bus master, the bus
master acknowledges the receipt of the data byte
in the same way. Data transfers are terminated by
a STOP condition after an Ack for WRITE, and af-
ter a NoACK for READ.
Power On Reset: V_CC Lock-Out Write Protect
In order to prevent data corruption and inadvertent
write operations during power up, a Power On Re-
set (POR) circuit is included. The internal reset is
held active until the V_CC voltage has reached the
POR threshold value, and all operations are dis-
abled – the device will not respond to any com-
mand. In the same way, when V_CC drops from the
operating voltage, below the POR threshold value,
all operations are disabled and the device will not
respond to any command. A stable and valid V_CC
must be applied before applying any logic signal.
Table 2. Absolute Maximum Ratings ¹
Symbol
Parameter
Value
Unit
T_A
Ambient Operating Temperature
0 to 70
°C
T_STG
Storage Temperature
Wafer form
Module form
-65 to 150
-40 to 120
°C
V_IO
Input or Output range
-0.6 to 6.5
V
V_CC
Supply Voltage
-0.3 to 6.5
V
VESD
Electrostatic Discharge Voltage (Human Body model) ²
Electrostatic Discharge Voltage (Machine model) ³
4000
V
400
V
Note: 1. Except for the rating “Operating Temperature Range”, stresses above those listed in the Table “Absolute Maximum Ratings” may
cause permanent damage to the device. These are stress ratings only, and operation of the device at these or any other conditions
above those indicated in the Operating sections of this specification is not implied. Exposure to Absolute Maximum Rating condi-
tions for extended periods may affect device reliability. Refer also to the ST SURE Program and other relevant quality documents.
2. MIL-STD-883C, 3015.7 (100 pF, 1500 Ω)
3. EIAJ IC-121 (Condition C) (200 pF, 0 Ω)
2/14