TDA7571 Datasheet, PDF (17/21 Pages) STMicroelectronics – STPDACsw - Fully digital high efficiency power audio amplifier

TDA7571
Functions, pins and components description
4.8
4.8.1
4.8.2
4.8.3
4.8.4
4.8.5
4.8.6
4.8.7
4.8.8
External connections description
CD, THWEXT, THWINT
These pins, if used, it must be connected to a pull-up resistor (>10kOhm) connected to a
supply voltage referred to the receiver device (as example, a µP).
Maximum voltage = 6V.
MUTE
Mute pin
ST-BY - St-By pin.
To avoid pop noise due to multiple ST-BY parasitic pulses, an R-C network must be added
(as example 47kOhm, 0.1µF)
+Vs-low -
This pin supply the low voltage circuits. It can be connected to the +Vs or to a reference
voltage comprising between 12V to +Vs.
A connection to +Vs through a 100Ohm resistor, together a 1uF capacitor placed from +Vs-
low and GND is possible too.
DATA, SEL, SCK
I²S digital inputs
MCLK
Master clock input. Must be F(MCLK) = 256 x Fs (11289.6kHz in case of Fs = 44.1 kHz)
DGND
Digital ground
BRIDGE and L/R
With this pin, the mode of working of the device (bridge or single-ended) can be selected.
If it is connected to the pin 32 (DGND) the device works in single-ended mode
If it is connected to the pin 40 (5Vdig) the device works in bridge mode.
In case of bridge mode, the pin 34 (L/R) makes the channel selection. If connected to
DGND, the Left channel is selected. If connected to 5Vdig, is selected the Right channel.
These pins must be selected with the device in ST-BY condition.
In case of single-ended operation, it is suggested to put the L/R pin at 5V.
17/21