AN977 Datasheet, PDF (16/17 Pages) STMicroelectronics – GUIDELINES FOR UPGRADING FROM THE ST92F120

GUIDELINES FOR UPGRADING FROM THE ST92F120 (0.50 µm) TO THE ST92F124...
3.3 HOW TO UPGRADE/RECONFIGURE YOUR ST9 HDS2V2 EMULATOR
The procedure tells you how to upgrade/reconfigure your ST9 HDS2V2 emulator. Be sure you
meet all the prerequisites before starting, otherwise you could damage your emulator by per-
forming this procedure.
1. Ensure that your ST9 HDS2V2 emulator is connected via the parallel port to your host PC
running either Windows ® 95, 98, 2000 or NT ®. If you are reconfiguring your emulator to
be used with a new probe, the new probe must be physically connected to the HDS2V2
main board using the three flex cables.
2. On the host PC, from Windows ®, select Start >Run....
3. Click the Browse button to browse to folder where you installed the ST9+ V6.1.1 Toolchain.
By default, the installation folder path is C:\ST9PlusV6.1.1\... In the installation folder,
browse to the ..\downloader\ subfolder.
4. Locate the ..\downloader\<ST9xxxx-EMU2>\ directory corresponding to the name of the
emulator you want to upgrade/configure.
For example, if you want to reconfigure your ST92F120 emulator to be used with the
ST92F150-EMU2 emulation probe, browse to the ..\downloader\<ST92F150-EMU2>\
directory.
5. Then select the directory corresponding to the version you wish to install (for example, the
V1.01 version is found in ..\downloader\<ST92F150-EMU2>\v1.01\) and select the file
<setup_st9xxxx.bat> (for example, setup_st92f150.bat).
6. Click on Open.
7. Click OK in the Run window. The update will begin. You have simply to follow the instruc-
tions displayed on your PC’s screen.
WARNING: Do not stop the emulator, or the program while the update is in progress! Your
emulator may be damaged!
16/17