STM32F745XX Datasheet, PDF(115/227 Page) STMicroelectronics – ARM-based Cortex-M7 32b MCU+FPU, 462DMIPS, up to 1MB Flash/320+16+ 4KB RAM, USB OTG HS/FS, ethernet, 18 TIMs, 3 ADCs, 25 com itf, cam & LCD

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

STM32F745XX Datasheet, PDF (115/227 Pages) STMicroelectronics – ARM-based Cortex-M7 32b MCU+FPU, 462DMIPS, up to 1MB Flash/320+16+ 4KB RAM, USB OTG HS/FS, ethernet, 18 TIMs, 3 ADCs, 25 com itf, cam & LCD

◁

STM32F745xx STM32F746xx

Electrical characteristics

Figure 29. Typical VBAT current consumption (RTC ON/BKP SRAM OFF and

LSE in high medium drive mode)

Ïµ

Ï´

Ï³

Ï²

ÏÍÏ²Ï±s

ÏÍÏ³s

Ï±

ÏÍÏ´s

Ï®s

Ï°

Ï®ÍÏ°s

Ï®ÍÏ³s

Ï¯

Ï¯s

Ï®

Ï¯ÍÏ¯s

Ï¯ÍÏ²s

Ï

Ï¬

Ï¬

Ï®Ï¬

Ï°Ï¬

Ï²Ï¬

Ï´Ï¬

ÏÏ¬Ï¬

ÏÏ®Ï¬

dÄÅµÆÄÆÄÆÆµÆÄÍ¾Î£Í¿

069

Caution:

I/O system current consumption

The current consumption of the I/O system has two components: static and dynamic.

I/O static current consumption

All the I/Os used as inputs with pull-up generate current consumption when the pin is

externally held low. The value of this current consumption can be simply computed by using

the pull-up/pull-down resistors values given in Table 56: I/O static characteristics.

For the output pins, any external pull-down or external load must also be considered to

estimate the current consumption.

Additional I/O current consumption is due to I/Os configured as inputs if an intermediate

voltage level is externally applied. This current consumption is caused by the input Schmitt

trigger circuits used to discriminate the input value. Unless this specific configuration is

required by the application, this supply current consumption can be avoided by configuring

these I/Os in analog mode. This is notably the case of ADC input pins which should be

configured as analog inputs.

Any floating input pin can also settle to an intermediate voltage level or switch inadvertently,

as a result of external electromagnetic noise. To avoid current consumption related to

floating pins, they must either be configured in analog mode, or forced internally to a definite

digital value. This can be done either by using pull-up/down resistors or by configuring the

pins in output mode.

I/O dynamic current consumption

In addition to the internal peripheral current consumption (see Table 35: Peripheral current

consumption), the I/Os used by an application also contribute to the current consumption.

When an I/O pin switches, it uses the current from the MCU supply voltage to supply the I/O

DocID027590 Rev 4

115/227

195

▷