SPC56EL60L5 Datasheet, PDF (1/160 Pages) STMicroelectronics – 32-bit Power Architecture® microcontroller for automotive SIL3/ASILD chassis and safety applications

SPC56EL60x, SPC56EL54x
SPC564L60x, SPC564L54x
32-bit Power Architecture® microcontroller for automotive
SIL3/ASILD chassis and safety applications
Datasheet − production data
Features
■ High-performance e200z4d dual core
– 32-bit Power Architecture^® technology CPU
– Core frequency as high as 120 MHz
– Dual issue five-stage pipeline core
– Variable Length Encoding (VLE)
– Memory Management Unit (MMU)
– 4 KB instruction cache with error detection
code
– Signal processing engine (SPE)
■ Memory available
– Up to 1 MB flash memory with ECC
– Up to 128 KB on-chip SRAM with ECC
– Built-in RWW capabilities for EEPROM
emulation
■ SIL3/ASILD innovative safety concept:
LockStep mode and Fail-safe protection
– Sphere of replication (SoR) for key
components (such as CPU core, eDMA,
crossbar switch)
– Fault collection and control unit (FCCU)
– Redundancy control and checker unit
(RCCU) on outputs of the SoR connected
to FCCU
– Boot-time Built-In Self-Test for Memory
(MBIST) and Logic (LBIST) triggered by
hardware
– Boot-time Built-In Self-Test for ADC and
flash memory triggered by software
– Replicated safety enhanced watchdog
– Replicated junction temperature sensor
– Non-maskable interrupt (NMI)
– 16-region memory protection unit (MPU)
– Clock monitoring units (CMU)
– Power management unit (PMU)
– Cyclic redundancy check (CRC) unit
LQFP144 (20 x 20 x 1.4 mm)
LQFP100 (14 x 14x 1.4 mm)
■ Decoupled Parallel mode for high-performance
use of replicated cores
■ Nexus Class 3+ interface
■ Interrupts
– Replicated 16-priority controller
– Replicated 16-channel eDMA controller
■ GPIOs individually programmable as input,
output or special function
■ Three 6-channel general-purpose eTimer units
■ 2 FlexPWM units
– Four 16-bit channels per module
■ Communications interfaces
– 2 LINFlexD channels
– 3 DSPI channels with automatic chip select
generation
– 2 FlexCAN interfaces (2.0B Active) with 32
message objects
– FlexRay module (V2.1 Rev. A) with 2
channels, 64 message buffers and data
rates up to 10 Mbit/s
■ Two 12-bit analog-to-digital converters (ADCs)
– 16 input channels
– Programmable cross triggering unit (CTU)
to synchronize ADCs conversion with timer
and PWM
■ Sine wave generator (D/A with low pass filter)
■ On-chip CAN/UART bootstrap loader
■ Single 3.0 V to 3.6 V voltage supply
■ Ambient temperature range –40 °C to 125 °C
■ Junction temperature range –40 °C to 150 °C
August 2012
This is information on a product in full production.
Doc ID 15457 Rev 8
1/160
www.st.com
1