EMC2300_11 Datasheet, PDF (77/82 Pages) SMSC Corporation – Fan Control Device with High Frequency PWM and Temperature Monitors

Chapter 10 Mechanical Specifications
3
D
e
16
3 E1
E
INDEX AREA
5 (D/2 X E1/2)
12
8X b ^{2 4}
TOP VIEW
SEE DETAIL "A"
4
c
END VIEW
REVISION
A
REVISION HISTORY
DESCRIPTION
INITIAL RELEASE
DATE
8/02/024
RELEASED BY
S.K.ILIEV
C
SEATING PLANE
A1
ccc C
SIDE VIEW
A2 _A
GAUGE PLANE
0.25
L
0
L1
DETAIL "A"
SCALE: 3/1
3-D VIEW
NOTES:
1. ALL DIMENSIONS ARE IN MILLIMETER.
2. TRUE POSITION SPREAD TOLERANCE IS ± 0.09 mm AT MAXIMUM MATERIAL CONDITION.
3. DIMENSION "D" DOES NOT INCLUDE MOLD FLASH, PROTRUSIONS OR GATE BURRS.
MAXIMUM MOLD FLASH, PROTRUSIONS OR GATE BURRS IS 0.15 mm PER END.
DIMENSION "E1" DOES NOT INCLUDE INTERLEAD FLASH OR PROTRUSION.
MAXIMUM INTERLEAD FLASH OR PROTRUSION IS 0.15 mm PER SIDE.
DIMENSIONS "D1" & "E1" ARE DETERMINED AT THE OUTERMOST EXTREMES OF THE
PLASTIC BODY, INCLUDING ANY MISMATCH BETWEEN THE TOP AND BOTTOM BODY.
4. DIMENSIONS "b" & "c" APPLY TO THE FLAT SECTION OF THE LEAD BETWEEN 0.10 TO
0.25 mm FROM THE LEAD TIP.
5. THE CHAMFER FEATURE IS OPTIONAL. IF IT IS NOT PRESENT, THEN A PIN 1 IDENTIFIER
MUST BE LOCATED WITHIN THE INDEX AREA INDICATED.
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS
AND TOLERANCES ARE:
DECIMAL
X.X ±0.1
X.XX ±0.05
X.XXX ±0.025
ANGULAR
±1°
DIM AND TOL PER ASME Y14.5M - 1994
MATERIAL
-
THIRD ANGLE PROJECTION
NAME
DRAWN
S.K.ILIEV
FINISH
-
C HECKED
S.K.ILIEV
PRINT WITH "SCALE TO FIT"
DO NOT SCALE DRAWING
APPR OVED
S.K.ILIEV
80 ARKAY DRIVE
HAUPPAUGE, NY 11788
USA
DATE
7/30/04
T IT LE
PACKAGE OUTLINE
16 PIN SSOP, 150x193mils BODY, 0.025" PITCH
DWG NUMBER
8/02/04
MO-16-SSOP-150x193
REV
A
SCALE
8/02/04
1:1
STD COMPLIANCE
JEDEC: MO-137 / B
SHEET
1 OF 1
Figure 10.1 16 Pin SSOP Package Outline and Parameters