COM20020_00 Datasheet, PDF (39/82 Pages) SMSC Corporation – Universal Local Area Network Controller with 2K x 8 On-Board RAM

Table 9 - Sub Address Register
BIT
BIT NAME
7-3 Reserved
2,1,0 Sub Address 2,1,0
SYMBOL
SUBAD
2,1,0
DESCRIPTION
These bits are undefined.
These bits determine which register at address 07 may be
accessed. The combinations are as follows:
SUBAD2
0
0
0
0
1
1
1
1
SUBAD1 SUBAD0 Register
0
0 Tentative ID \ (Same
0
1 Node ID
\ as in
1
0 Setup 1 / Config
1
1 Next ID / Register)
0
0 Setup 2
0
1 Reserved
1
0 Reserved
1
1 Reserved
SUBAD1 and SUBAD0 are exactly the same as exist in the
Configuration Register. SUBAD2 is cleared automatically by
writing the Configuration Register.
7 Reset
6 Command
Chaining Enable
Table 10 - Configuration Register
RESET
A software reset of the COM20020 is executed by writing a
logic "1" to this bit. A software reset does not reset the
microcontroller interface mode, nor does it affect the
Configuration Register. The only registers that the software
reset affect are the Status Register, the Next ID Register, and
the Diagnostic Status Register. This bit must be brought
back to logic "0" to release the reset.
CCHEN
This bit, if high, enables the Command Chaining operation of
the device. Please refer to the Command Chaining section
for further details. A low level on this bit ensures software
compatibility with previous SMSC ARCNET devices.
39
DISCONTINUED DATASHEET