AAT2601B Datasheet, PDF (31/39 Pages) Skyworks Solutions Inc. – Total Power Solution for Portable Applications

DATA SHEET
AAT2601B
Total Power Solution for Portable Applications
Transferring Data
Every byte on the bus must be 8 bits long. A byte is
always sent with a most significant bit first (see Figure
8).
MSB
LSB R/W
Figure 8: Bit Order.
The address is embedded in the first seven bits of the
byte. The eighth bit is reserved for the direction of the
information flow for the next byte of information. For the
AAT2601B, this bit must be set to “0”. The full 8-bit
address including the R/W bit is 0x98 (hex) or 10011000
in binary.
Acknowledge Bit
The acknowledge bit is the ninth bit of data. It is used to
send back a confirmation to the master that the data has
been received properly. For acknowledge to take place,
the MASTER must first release the SDA line, then the
SLAVE will pull the data line low as shown in Figure 7.
Serial Programming Code
After sending the chip address, the master should send
an 8-bit data stream to select which register to program
and then the codes that the user wishes to enter.
Register 0x00:
Timer
RCHG₁
Register 0x01:
Not used
Not used
Register 0x02:
LDO5₁
LDO5₀
RCHG₀
CHG₂
CHG₁
CHG₀
Not used
Not used
Not used
SYS
LDO4₁
LDO4₀
LDO3₁
LDO3₀
Figure 9: Serial Programming Register Codes.
Term₁
LDO1₁
LDO2₁
Term₀
LDO1₀
LDO2₀
USE_USB Pin
1
0
X
X
X
X
X
X
X
CHG₂
0
0
0
0
0
1
1
1
1
CHG₁
0
0
0
1
1
0
0
1
1
CHG₀
0
0
1
0
1
0
1
0
1
Constant Current Charge
I_{CH_CC}
100mA
(fixed internally)
800mA
(set by I_SET resistor)
640mA
480mA
320mA
960mA
1120mA
1280mA
1440mA
Constant Current Charge as
% of I_SET Current
(default)
100% (default)
80%
60%
40%
120%
140%
160%
180%
Table 3: CHG Bit Setting for the Constant Current Charge Level
(assuming I_SET resistor is set to default 800mA charge current).
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
202181B • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice. • March 19, 2013
31