SI4438 Datasheet, PDF (33/44 Pages) Silicon Laboratories – Low active power consumption

Si4438
Figure 13. RX and TX LDC Sequences
The basic operation of RX LDC mode is shown in Figure 14. The receiver periodically wakes itself up to work on
RX_STATE during LDC mode duration. If a valid preamble is not detected, a receive error is detected, or an entire
packet is not received, the receiver returns to the WUT state (i.e., ready or sleep) at the end of LDC mode duration
and remains in that mode until the beginning of the next wake-up period. If a valid preamble or sync word is
detected, the receiver delays the LDC mode duration to receive the entire packet. If a packet is not received during
two LDC mode durations, the receiver returns to the WUT state at the last LDC mode duration until the beginning
of the next wake-up period.
Figure 14. Low Duty Cycle Mode for RX
In TX LDC mode, the transmitter periodically wakes itself up to transmit a packet that is in the data buffer. If a
packet has been transmitted, nIRQ goes low if the option is set in the INT_CTL_ENABLE property. After
transmitting, the transmitter immediately returns to the WUT state and stays there until the next wake-up time
expires.
Rev 1.0
33