SI824X Datasheet, PDF (22/30 Pages) Silicon Laboratories – CLASS D AUDIO DRIVER WITH PRECISION DEAD-TIME GENERATOR

Si824x
3.8. Programmable Dead Time and Overlap Protection
All high-side/low-side drivers (Si8241/4) include programmable overlap protection to prevent outputs VOA and
VOB from being high at the same time. These devices also include programmable dead time, which adds a user-
programmable delay between transitions of VOA and VOB. When enabled, dead time is present on all transitions,
even after overlap recovery. The amount of dead time delay (DT) is programmed by a single resistor (RDT)
connected from the DT input to ground per Equation 5. Minimum dead time (approximately 400 ps) can be
achieved by connecting the DT pin to VDDI. Note that dead time accuracy is limited by the resistor’s (R_DT)
tolerance and temperature coefficient. See Figures 37 and 38 for additional information about dead time operation.
DT  10  RDT
where:
DT= dead time (ns)
and
RDT= dead time programming resistor (k 
Equation 5.
1000
900
800
700
600
500
400
300
200
100
0
0
20
40
60
80
100
Dead-time Resistance (k:)
Figure 37. Dead Time vs.Resistance (R_DT)
100
90
R_DT = 10k
80
70
R_DT = 6k
60
R_DT = 5k
50
R_DT = 4k
40
30
R_DT = 3k
20
R_DT = 2k
10
R_DT = 1k
0
R_DT = 0
-40 -20 0 20 40 60 80 100 120
Temperature (°C)
Figure 38. Dead Time vs.Temperature
22
Rev. 1.0