SLWSTK6101B Datasheet, PDF (13/84 Pages) Silicon Laboratories – BGM113 Blue Gecko Bluetooth ® Module Data Sheet

4. Electrical Specifications
BGM113 Blue Gecko Bluetooth ^® Module Data Sheet
Electrical Specifications
4.1 Electrical Characteristics
All electrical parameters in all tables are specified under the following conditions, unless stated otherwise:
• Typical values are based on T_AMB=25 °C and V_DD= 3.3 V, by production test and/or technology characterization.
• Radio performance numbers are measured in conducted mode, based on Silicon Laboratories reference designs using output pow-
er-specific external RF impedance-matching networks for interfacing to a 50 Ω antenna.
• Minimum and maximum values represent the worst conditions across supply voltage, process variation, and operating temperature,
unless stated otherwise.
Refer to Table 4.2 General Operating Conditions on page 13 for more details about operational supply and temperature limits.
4.1.1 Absolute Maximum Ratings
Stresses above those listed below may cause permanent damage to the device. This is a stress rating only and functional operation of
the devices at those or any other conditions above those indicated in the operation listings of this specification is not implied. Exposure
to maximum rating conditions for extended periods may affect device reliability. For more information on the available quality and relia-
bility data, see the Quality and Reliability Monitor Report at http://www.silabs.com/support/quality/pages/default.aspx.
Table 4.1. Absolute Maximum Ratings
Parameter
Symbol
Storage temperature range T_STG
External main supply voltage V_DDMAX
External main supply voltage V_DDRAMPMAX
ramp rate
External main supply voltage
with DC-DC in bypass mode
Voltage on any 5V tolerant
GPIO pin¹
V_DIGPIN
Test Condition
Min
Typ
-40
—
0
—
—
—
1.85
-0.3
—
Voltage on non-5V tolerant
GPIO pins
-0.3
—
Max RF level at input
P_RFMAX2G4
—
—
Total current into VDD power I_VDDMAX
lines (source)
—
—
Total current into VSS
ground lines (sink)
I_VSSMAX
—
—
Current per I/O pin (sink)
Current per I/O pin (source)
I_IOMAX
—
—
—
—
Current for all I/O pins (sink)
Current for all I/O pins
(source)
I_IOALLMAX
—
—
—
—
Voltage difference between ΔV_DD
AVDD and VREGVDD
—
—
Note:
1. When a GPIO pin is routed to the analog module through the APORT, the maximum voltage = IOVDD.
Max
Unit
+85
°C
3.8
V
1
V / μs
3.8
V
Min of 5.25 V
and IOVDD
+2
IOVDD+0.3 V
10
dBm
200
mA
200
mA
50
mA
50
mA
200
mA
200
mA
0.3
V
silabs.com | Smart. Connected. Energy-friendly.
Rev. 1.00 | 12