S-24CS16A Datasheet, PDF (26/53 Pages) Seiko Instruments Inc – 2-WIRE CMOS SERIAL E2PROM

2-WIRE CMOS SERIAL E²PROM
S-24CS16A
Rev.4.3_00
6. Data hold time (t_HD.DAT = 0 ns)
If SCL and SDA of the E²PROM are changed at the same time, it is necessary to prevent the start / stop condition from
being mistakenly recognized due to the effect of noise. If a start/stop condition is mistakenly recognized during
communication, the E²PROM enters the standby status.
It is recommended that SDA is delayed from the falling edge of SCL by 0.3 µs minimum in the S-24CS16A. This is to
prevent time lag caused by the load of the bus line from generating the stop (or start) condition.
t_HD.DAT = 0.3 µs Min.
SCL
SDA
Figure 31 E²PROM Data Hold Time
7. SDA pin and SCL pin noise suppression time
The S-24CS16A includes a built-in low-pass filter to suppress noise at the SDA and SCL pins. This means that if the
power supply voltage is 5.0 V, noise with a pulse width of 160 ns or less can be suppressed.
The guaranteed for details, refer to noise suppression time (t_I) in Table 14.
300
Noise suppression time (t_I) Max. ₂₀₀
[ns]
100
2
3
4
5
Power supply voltage (V_CC)
[V]
Figure 32 Noise Suppression Time for SDA and SCL Pins
26
Seiko Instruments Inc.