S-25C010A Datasheet, PDF (18/37 Pages) Seiko Instruments Inc – CMOS SPI SERIAL E2PROM

CMOS SPI SERIAL E²PROM
S-25C010A/020A/040A
Rev.1.0_00
7. Write memory data (WRITE)
Figure 17 and 18 show the timing chart when inputting 1-byte data. Input the instruction code, the address and data
from serial data input (SI) after inputting “L” to the chip select ( CS ). To start Write (t_PR), set the chip select ( CS ) to “H”
after inputting data or before inputting a rising of the next serial clock. Bit WIP is reset to “0” when Write has completed.
The S-25C010A/020A/040A can Page Write of 16 bytes. Its function to transmit data is as same as Byte Write basically,
but it operates Page Write by receiving sequential 8-bit Write data as much data as page size has. Input the instruction
code, the address and data from serial data input (SI) after inputting “L” in CS , as the WRITE operation (page) shown in
Figure 19 and 20. Input the next data while keeping CS in “L”. After that, repeat inputting data of 8-bit sequentially. At
the end, by setting CS to “H”, the WRITE operation starts (t_PR).
5 of the lower bits in the address are automatically incremented every time when receiving Write data of 8-bit. Thus,
even if Write data exceeds 16 bytes, the higher bits in the address do not change. And 4 of lower bits in the address roll
over so that Write data which is previously input is overwritten.
These are cases when the WRITE instruction is not accepted or operated.
• Bit WEL is not set to “1” (not set to “1” beforehand immediately before the WRITE instruction)
• During Write
• The address to be written is in the protect area by BP1 and BP0.
• The signal WP is in “L”.
To cancel the WRITE instruction, input the clock different from a specified value (n = 16+m × 8clock) while CS is in “L”.
18
Seiko Instruments Inc.