|
S-25C010A Datasheet, PDF (13/37 Pages) Seiko Instruments Inc – CMOS SPI SERIAL E2PROM | |||
|
◁ |
Rev.1.0_00
CMOS SPI SERIAL E2PROM
S-25C010A/020A/040A
3. Write disable (WRDI)
The WRDI instruction is one of ways to reset bit Write Enable Latch (WEL). After selecting the device by the chip select
( CS ), input the instruction code from serial data input (SI).
To reset bit WEL, set the device in the non-select status by CS at the 8th clock of the serial clock. To cancel the WRDI
instruction, input the clock different from a specified value (n = 8 clock) while CS is in âLâ.
Bit WEL is reset after the operations shown below.
⢠The power supply voltage is dropping
⢠Power on
⢠After performing WRDI
⢠After the completion of Write operation by the WRSR instruction
⢠After the completion of Write operation by the WRITE instruction
⢠After setting the WP pin to âLâ
CS
WP
High / Low
SCK
SI
SO
Remark X = Donât care.
1
2
3
4
5
6
7
8
Instruction
X
High-Z
Figure 12 WRDI operation
Seiko Instruments Inc.
13
|
▷ |