LQ035Q7DH06 Datasheet, PDF (20/26 Pages) Sharp Electrionic Components – TFT-LCD Module

LCP-05020-17
12-3-2) Mounting on display and housing bezel
(1)In all cases, the T/P should be supported from the backside of the Plastic.
(2)Do not to use an adhesive-tape to bond it on the front of T/P and hang it to the housing bezel.
(3)Never expand the T/P top layer (PET-film) like a balloon by internal air pressure.
The life of the T/P will be extremely short.
(4)Top layer, PET, dimension is changing with environmental temperature and humidity.
Avoid a stress from housing bezel to top layer, because it may cause “waving”.
(5)The input to the Touchpanel sometimes distorts touch panel itself.
Housing
Cushion material
(=Gasket Area)
PET Film
0.3
～0.7mm
Insulation metal
Transparent
Insulation Paste
Response Area
Electrode
Layer
Glass
Prohibition Area
Fig.2