LQ104V1DG51 Datasheet, PDF (17/21 Pages) Sharp Electrionic Components – TFT LCD MODULE

LD13708-15
10. Display Quantity
The display quality of the color TFT-LCD module shall be in compliance with the
Incoming Inspection Standard.
11．Handling Precautions
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as
warp or twist.
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
Handle with care.
g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth
when handling.
h) Observe all other precautionary requirements in handling components.
i) This module has its circuitry PCBs on the rear side and should be carefully handled in order not
to be stressed.
j) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching
protective board over the LCD. Be careful about the optical interface fringe etc.
Which degrades display quality.
k) Connect GND to 4 place of mounting holes to stabilize against EMI and external noise.
l) There are high voltage portions on the backlight and very dangerous. Careless touch may lead to
electrical shock. When exchange lamps or service. Turn off the power without tail.
m) Be sure not to apply tensile stress to the lamp lead cable.
12.Packing form
Product country
JAPAN
Piling number of cartons
７（Max）
Packing quantity in one carton 20
Carton size　[mm]
494(W)×326(D)×433(H)
Total mass of one carton filled 15.6kg
with full modules
Packing form is shown
Fig.1-2