GS4915 Datasheet, PDF (7/27 Pages) Gennum Corporation – ClockCleaner™

Table 1-1: Pin Descriptions (Continued)
Pin
Number
18
19
21
23
24
25
27
29, 28
32
33,34
35
Name
DOUBLE
Timing
Non
synchronous
SKEW_EN
Non
synchronous
LOCK
Non
synchronous
SE_VDD
–
CLKOUT_SE
–
D_VDD
–
DIFF_OUT_VDD
–
CLKOUT, CLKOUT –
DIV_VDD
VCO, VCO
VCO_GND
–
Analog
–
Type Description
Input
CONTROL SIGNAL INPUT
Signal levels are LVCMOS compatible.
Controls the output frequency of the cleaned clock, for HD input
clocks.
See Section 3.5 for operation.
Input
CONTROL SIGNAL INPUT
Signal levels are LVCMOS compatible.
Selects the phase of the output clock with respect to the selected input
clock.
See Section 3.6 for operation.
Outpu
t
STATUS SIGNAL OUTPUT
Signal levels are LVCMOS compatible.
This pin will be HIGH when the output clock is locked to the selected
input clock.
It will be LOW otherwise.
Power
Positive power supply connection for the single-ended clock driver.
Determines the output level of CLKOUT_SE. Connect to filtered +1.8V
DC or +3.3V DC.
NOTE: If the single-ended clock output is not used, this pin should be
tied to ground.
Outpu
t
CLOCK SIGNAL OUTPUT
Signal levels are LVCMOS compatible.
Single-ended video clock output signal.
See Section 3.7.2 for operation.
Power
Positive power supply connection for the single-ended output clock
buffer. Connect to filtered +1.8V DC.
NOTE: If the single-ended clock output is not used, this pin should be
tied to ground.
Power
Positive power supply connection for the LVDS clock outputs. Connect
to filtered +1.8V DC.
NOTE: If the LVDS clock outputs are not used, this pin should be tied to
ground.
Outpu
t
CLOCK SIGNAL OUTPUT
Differential video clock output signal.
This is the lowest jitter output of the device.
See Section 3.7.1 for operation.
Power Positive power supply connection for the divider block. Connect to
filtered +1.8V DC.
Input
Differential input for the external VCO reference signal. When using
the recommended VCO, leave VCO unconnected.
See Section 3.3.4 for operation.
Power Ground reference for the external voltage controlled oscillator.
Connect to pins 2, 4, 6, and 8 of the GO1555.
GS4915 ClockCleaner™
Data Sheet
39145 - 5
June 2009
7 of 27