GS6151 Datasheet, PDF (65/77 Pages) Semtech Corporation – Multi-Rate 6G UHD-SDI

Table 5-1: Register Descriptions - Standard Address Space (Continued)
Address Register Name Parameter Name
36_h
EYE_MON_
STATUS_REG_10
EYE_BITMAP_31_16
37_h
EYE_MON_
STATUS_REG_11
EYE_BITMAP_15_0
RSVD
38_h
EYE_MON_
STATUS_REG_12
EYE_MON_PRBS_NODATA
RSVD
RSVD
PRBS_MON_NODATA_SET
39_h PRBS_CHK_CTRL
RSVD
PRBS_MON_ENABLE
Bit
Slice
R/W
Reset
Value
Description
15:0 RO
15:0 RO
15:11 RO
10:10 RO
9:0 RO
15:4 RW
3:3 RW
2:1 RW
0:0 RW
Bitmap of the per-phase pass/fail result from
the most recent automatic
(AUTO_SCAN_START) scan measurement for
phases 31 to 16.
A value of 1 in each bit indicates a pass for
0_h the corresponding phase, while a value of 0
indicates a fail for that phase.
The order of the numbers shown in the
Parameter Name field corresponds to the bit
orientation for each phase being reported in
this register.
Bitmap of the per-phase pass/fail result from
the most recent automatic
(AUTO_SCAN_START) scan measurement for
phases 15 to 0.
A value of 1 in each bit indicates a pass for
0_h the corresponding phase, while a value of 0
indicates a fail for that phase.
The order of the numbers shown in the
Parameter Name field corresponds to the bit
orientation for each phase being reported in
this register.
0_h Reserved. Do not change.
When HIGH, indicates that no data
transitions have been detected in the PRBS
0_h checker since the
EYE_MON_PRBS_NODATA_SET was last set
to 1.
0_h Reserved. Do not change.
0_h Reserved. Do not change.
When HIGH, sets a latch in the Retime PRBS
checker (PRBS_MON_NODATA bit of
PRBS_STATUS_REG_11) HIGH. This bit must
0_h
be set LOW before checking the
PRBS_MON_NODATA bit. The
PRBS_MON_NODATA bit will then be
automatically set LOW if transitions are
detected.
1_h Reserved. Do not change.
0_h
When asserted the Re-time PRBS7 checker
circuit is enabled.
GS6151
Final Data Sheet
PDS-060389
Rev.4
August 2015
www.semtech.com
65 of 77
Semtech
Proprietary & Confidential