GS6151 Datasheet, PDF (59/77 Pages) Semtech Corporation – Multi-Rate 6G UHD-SDI

Table 5-1: Register Descriptions - Standard Address Space (Continued)
Address Register Name
Parameter Name
RSVD
EYE_MON_PRBS_NODATA_
23_h
EYE_MON_
ENABLE
SET
HORIZONTAL_EYE_MON_
ENABLE
RSVD
MANUAL_SCAN_START
24_h
EYE_MON_SCAN
_START
AUTO_SCAN_START
Bit
Slice
R/W
Reset
Value
Description
15:2 RW 0_h Reserved. Do not change.
When HIGH, sets a latch in the Input PRBS
checker (EYE_MON_PRBS_NODATA bit of
EYE_MON_STATUS_REG_12) HIGH. This bit
1:1
RW
0_h
must be set LOW before checking the
EYE_MON_PRBS_NODATA bit. The
EYE_MON_PRBS_NODATA bit will then be
automatically set LOW if transitions are
detected.
Enables the horizontal eye monitor.
0:0
RW
0_h 00_b: Horizontal Eye Monitor disabled
01_b: Horizontal Eye Monitor enabled
15:2 ROSW 0_h Reserved. Do not change.
Writing a 1 to this bit triggers the start of a
manually timed horizontal eye scan using
the parameters defined in
1:1 ROSW 0_h ^{EYE_MON_CONTROL_REG_[0:6] registers.}
The bit then becomes read-only, and will be
reset to a value of 0 by the device to indicate
when the scan is complete.
Writing a 1 to this bit triggers the start of an
automatic horizontal eye scan using the
device’s default parameters.
0:0 ROSW 0_{h The bit then becomes read-only, and will be}
reset to a value of 0 by the device to indicate
when the scan is complete.
GS6151
Final Data Sheet
PDS-060389
Rev.4
August 2015
www.semtech.com
59 of 77
Semtech
Proprietary & Confidential