English
Language : 

GS2960 Datasheet, PDF (64/97 Pages) Semtech Corporation – 3Gb/s, HD, SD SDI Receiver Complete with SMPTE Video Processing
• The VD_STD_ERR bit is not valid
• 352M extraction is only done on one data stream or the other, not both
simultaneously (Link A or Link B selected via the host interface)
• Previously embedded 352M packets can be deleted on one data stream only (using
the ANC_DATA_DELETE bit, see Section 4.18.8), but these packets are replaced with
10-bit Y/C blanking values only
• It is necessary to manually extract the SMPTE 352M data by programming the DID,
SDID and line number information into the ANC data extraction block
NOTE 2: SMPTE 352M packet regeneration is enabled by default for 3G Level B inputs,
and should be disabled through the host interface if Level B to Level A conversion is not
enabled.
4.17.2.1 SMPTE 352M Payload Identifier Usage
The SMPTE 352M Payload Identifier is used to confirm the video format identified by the
Automatic Video Standards Detection block (see Section 4.17.4)
Table 4-13: SMPTE 352M Packet Data
Bit Name
VIDEO_FORMAT_4_DS1
Address: 01Ah
VIDEO_FORMAT_3_DS1
Address: 01Ah
VIDEO_FORMAT_2_DS1
Address: 019h
VIDEO_FORMAT_2_DS1
Address: 019h
Bit
Name
15-8 SMPTE 352M
Byte 4
7-0 SMPTE 352M
Byte 3
15-8 SMPTE 352M
Byte 2
7-0 SMPTE 352M
Byte 1
Description
Data is available in this register when Video Payload
Identification Packets are detected in the data
stream.
R/W
R
R
Default
0
0
R
0
R
0
4.17.2.2 3G SMPTE 352M Packets Following Level B to Level A Conversion
After Level B to Level A conversion, modified payload data must be programmed via the
host interface into the VIDEO_FORMAT_352_X_X registers and automatically inserted
by the GS2960 on the correct SMPTE 352M Line Number.
SMPTE 352M Packets are embedded in both data streams.
Previously embedded 352M packets may be deleted from one data stream only (using
the ANC_DATA_DELETE bit, see Section 4.18.8), but these packets are replaced with
10-bit Y/C blanking values.
NOTE: Pre-existing SMPTE 352M Packets that are not deleted are re-mapped to
different line numbers during conversion to Level A formatting. These packets should be
ignored by the system, since they are on non-standard SMPTE 352M lines.
4.17.3 Ancillary Data Checksum Error
The GS2960 calculates checksums for all received ancillary data.
GS2960 3Gb/s, HD, SD SDI Receiver Complete with
SMPTE Video Processing
Data Sheet
48003 - 6
September 2012
64 of 97