LC88F58B0A Datasheet, PDF (5/25 Pages) Sanyo Semicon Device – FROM 128K byte, RAM 4096K byte on-chip 16-bit 1-chip Microcontroller

LC88F83B0A
„Standby Function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) Released by a system reset or occurrence of an interrupt.
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) OSC1, internal RC and X’tal oscillators automatically stop operation.
2) There are the following methods of resetting the HOLD.
(1) Setting the reset pin to the low level
(2) Having an interrupt source established in the SIO0
(3) Having an interrupt source established in the UART2
(4) Having an interrupt source established in the P00 to P05
(5) Having an interrupt source established in the SEG71 to SEG64
• X’tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except using OSC0.
1) The OSC1 and internal RC oscillators automatically stop operation.
2) The state of OSC0 oscillation established when the X'tal HOLD mode is entered is retained.
3) There are the following methods of resetting the X'tal HOLD mode.
(1) Setting the reset pin to the low level
(2) Having an interrupt source established in the base timer circuit
(3) Having an interrupt source established in the timers 0, 1, 3, 4, 5
(4) Having an interrupt source established in the SIO0
(5) Having an interrupt source established in the UART2
(6) Having an interrupt source established in the P00 to P05
(7) Having an interrupt source established in the SEG71 to SEG64
„On-chip debugger
• Supports software debugging with the IC mounted on the target board.
• Supports tracing, realtime monitoring, and breakpoint setting.
• Single-wire communication
„Package Form
• TQFP120(14×14): Lead-free type
„Development Tools
• On-chip debugger : EOCUIF1 + LC88F83B0A
• Programming boards :
Package Dimensions
unit : mm (typ)
3257A
16.0
14.0
120
1
0.4
0.15
(1.2)
0.125
SANYO : TQFP120(14X14)
No.A1228-5/25