LC86F3G64A Datasheet, PDF (5/25 Pages) Sanyo Semicon Device – 8-bit 1-chip Microcontroller

LC86F3G64A
• Interrupt priority control
Three interrupt priorities are supported (low, high and highest) and multi-level nesting is possible.
Low or high priority can be assigned to the interrupts from 3 to 10 listed above.
For the external interrupt INT0 and INT1, low or highest priority can be set.
„Sub-routine Stack Level
• A maximum of 128 levels (stack area is assigned on the internal RAM)
„Multiplication/Division Instruction
• 16 bits×8 bits (7 instruction cycle times)
• 16 bits÷8 bits (7 instruction cycle times)
„3 Oscillation Circuits
• Built-in RC oscillation circuit used for the system clock
• Built-in VCO circuit used for the system clock and OSD clock
• On-chip X’tal oscillation circuit used for PLL reference and the system clock and base timer clock
„Standby Function
• HALT mode
The HALT mode is used to reduce the power dissipation. In this operation mode, the program execution is stopped.
This mode can be released by the interrupt request or the system reset.
• HOLD mode
The HOLD mode is used to stop the oscillations; RC (internal), VCO, and X’tal oscillations. This mode can be
released by the following conditions.
- Pull the reset terminal (RES) to low level.
- Feed the selected level to either P70/INT0 or P71/INT1.
- Feed the Port 0 interrupt condition
„Applicable Mask ROM Version
• LC863G64/LC863G56/LC863G48/LC863G40/LC863G32/LC863G28/LC863G24
• LC863864/LC863856/LC863848/LC863840/LC863832/LC863828/LC863824/LC863820/LC863816
• LC863364/LC863356/LC863348/LC863340/LC863332/LC863328/LC863324/LC863320/LC863316
• LC863264/LC863256/LC863248/LC863240/LC863232/LC863228/LC863224/LC863220/LC863216
„Package
• DIP42S (Lead-free type)
• QIP48E (Lead-free type)
„Development Tools
• Evaluation chip: LC863096
• Emulator:
LC863G00 series: Special ROM monitor tool
(When debugging it, one terminal in the I/O port is used as a pin only for the tool)
LC863800 series:EVA86000(main) + ECB863200A (evaluation chip board)
+ POD863200 (pod:DIP42S) [Shared with LC8632 Series]
or POD863201 (QIP48E) [Shared with LC8632 Series]
LC863300 series:EVA86000(main) + ECB863200*1 or ECB863200A (evaluation chip board)
+ POD863300 (pod:DIP42S) or POD863301 (QIP48E)
LC863200 series: EVA86000(main) + ECB863200*1 or ECB863200A (evaluation chip board)
+ POD863200 (pod:DIP42S) or POD863201 (QIP48E)
*1 This product is no longer available
Write Flash Memory
SANYO provides special services including writing data to Flash Memory and stamping.
There is a charge for these services.
Please feel free to ask our sales persons for details.
No.A0121-5/25