LC86F3G64A Datasheet, PDF (13/25 Pages) Sanyo Semicon Device – 8-bit 1-chip Microcontroller

LC86F3G64A
Method of how to rewrite it in FLASH programmer / SANYO FLASH writing tool (SFWS)
When reading or writing data to the LC86F3G64A, FLASH programmer of our recommendation or SANYO FLASH
writing tool (SFWS) is used. In both cases, exclusive conversion board (W86F3264D, W86F3264Q) is needed.
(1) FLASH programmer of our recommendation
Single Word Write
Manufacture
Name of device
version
Flash Support Group co.
(the former Ando Electric)
AF9708
Rev2.43
applicable device (code)
SANYO
LC86F3G64A (3B225)
Data protection setting
after write operation
Protected
Write Multiple Words
Manufacture
Name of device
Flash Support Group co.
(the former Ando Electric)
AF9723 +
AF9833
*1: Registration is being requested.
version
Rev2.04
+Rev01.85
*1
applicable device (code)
SANYO
LC86F3G64A (3B225)
Data protection setting
after write operation
Protected
The LC86F3G64A does not support a silicon signature feature.
Do not use the feature (automatic device type selection) when programming this device.
To avoid erasing the program, confirm the setting of the protection for activating the written program before using.
It can’t be written with device code 29EE010
(2) SANYO FLASH writing tool (SFWS)
PC is connected with writer unit (SKK) by USB cable and it uses it.
(3) Exclusive writing conversion board
• W86F3264D • • • DIP42S purpose (It is common with production discontinuance model
(LC86F3264A/LC86F3364A/LC86F3864A) )
• W86F3264Q • • • QIP48E purpose (It is common with production discontinuance model
(LC86F3264A/LC86F3364A/ LC86F3864A) )
When using the conversion board, all of the jumper SW must be set to the OFF position.
If set to the ON position, read/write operations will not perform correctly.
Pin 1 of the conversion board should be located as indicated below.
W86F3264D: when viewing from the edge closest to jumper SW, pin 1 is located on the lower right of both the chip
and conversion board.
W86F3264Q: when viewing from the edge closest to jumper SW, pin 1 of the chip is located on the upper right
while pin 1 of the conversion board is located on the lower right.
Chip: pin 1
Pin 1
Set jumper SW to OFF
W86F3264D
Pin 1
Set jumper SW to OFF
W86F3264Q
No.A0121-13/25