LV24100LP Datasheet, PDF (2/18 Pages) Sanyo Semicon Device – Bi-CMOS IC FM and AM Tuner IC for Small Portable Equipment

LV24100LP
Specifications
Maximum Ratings at Ta = 25°C
Parameter
Symbol
Conditions
Maximum supply voltage
VCC max Analog block supply voltage
VDD max Digital block supply voltage
Digital input voltage
VIN1 max Clock, Data, NR_W
VIN2 max External_clk_in
Allowable power dissipation
Pd max Ta≤70°C, Mounted on a specified board *
Operating temperature
Topr
Storage temperature
Tstg
Note: Mounted on a specified board: 40mm×50mm×0.8mm, glass epoxy
Ratings
Unit
5.0
V
4.5
V
VDD+0.3
V
VDD+0.3
V
140
mW
-20 to +70
°C
-40 to +125
°C
Operating Condition at Ta = 25°C
Parameter
Symbol
Conditions
Ratings
Unit
Recommended supply voltage
VCC
Analog block supply voltage
3.0
V
VDD
Digital block supply voltage
3.0
V
Operating supply voltage range
VCC op
3.0 to 4.8
V
VDD op
3.0 to 4.0
V
VIO op
Interface voltage
1.8 to 4.0
V
Note: The VIO application voltage must be either equivalent to VDD or the VDD value or less. (VIO ≤ VDD)
Interface Block Allowable Operation Range at Ta = -20 to +70°C, VIO = 3.0V, VSS = 0V
Parameter
Symbol
Conditions
Ratings
Unit
min
typ
max
Supply voltage
VDD
2.5
4.0
V
Digital block input
VIH
High level input voltage range
0.7VDD
VDD
V
VIL
Low level input voltage range
0
0.6
V
Digital block output
IOL
Output current at Low level
2.0
mA
Clock input operating frequency
VOL
fclk
Output voltage at Low level IOL=2mA
(Pin29) clock frequency for 3wire_bus
0.6
V
0.7 MHz
External clock operating frequency
fclk_ext (Pin31) clock frequency for external input
32k
14M
Hz
External clock operating voltage
Vclk_ext (Pin31) clock voltage for external input
0.7VDD
VDD
V
Note: External clock input (pin31) allows also input of the sine wave signal. Frequency deviation is need 250ppm.
No.A0194-2/18