SA2030 Datasheet, PDF (1/12 Pages) Sames – PCM FRAME ALIGNER

sames
SA2030
SA2030
PCM FRAME ALIGNER
FEATURES
n Frame Alignment Recovery and loss n Indication of Slip, loss of frame
in accordance with CCITT
synchronisation, and loss of route clock
recommendations G.732 and G.737
conditions.
n Jitter and phase-wander immunity n ISO-CMOS technology, TTL
exceed the requirements of CCITT
Compatible.
recommendation G.823.
n Pin-for-Pin replacement for Siemens
n Internal 1½ frame elastic buffer.
PEB 2030 and SM 300
n Detection of incoming Alarm- ^{n Microprocessor Interface}
Indication-Signal (AIS), and Distant
Alarm
APPLICATIONS
n Delay compensation and clock n Delay compensation between switching
alignment between 2,048MHz PCM-
stages.
30 transmission lines, and terminating
equipment.
n
Interfacing of PCM systems operating
with different clocks.
n
Control of Jitter and Wander within
Digital Networks.
n
PCM concentrators and subscriber
multiplexers.
GENERAL DESCRIPTION
The SA2030 is designed to interface PCM-30 routes with switching systems. The device
synchronises with the frame-format of the incoming data, and outputs this data in
accordance with the bit and frame timing of the terminating equipment. The circuit is
designed to tolerate delay, drift, wander and jitter of the incoming data and clock, and thus
simplifies the design of data- and clock-recovery hardware. The internal 1½ frames
elastic buffer provides for delay compensation and wander immunity. If the bounds of
the buffer are exceeded, the SA2030 will either repeat or drop a frame. The circuit will
accurately detect incoming Alarm-Indication-Signal (AIS) conditions, in accordance with
CCITT recommendation G.737. Loss of frame alignment is indicated on both dedicated
outputs and by outputting of AIS. The circuit includes a bidirectional alarm port for
interrogation of alarm conditions.
M74-1885
sames
1/12
20.01.93