RF5110G Datasheet, PDF (17/18 Pages) RF Micro Devices – 3V GSM POWER AMPLIFIER

RF5110G
Tape and Reel Information
Carrier tape basic dimensions are based on EIA481. The pocket is designed to hold the part for shipping and loading
onto SMT manufacturing equipment, while protecting the body and the solder terminals from damaging stresses. The
individual pocket design can vary from vendor to vendor, but width and pitch will be consistent.
Carrier tape is wound or placed onto a shipping reel either 330 mm (13 inches) in diameter or 178 mm (7 inches) in
diameter. The center hub design is large enough to ensure the radius formed by the carrier tape around it does not put
unnecessary stress on the parts.
Prior to shipping, moisture sensitive parts (MSL level 2a-5a) are baked and placed into the pockets of the carrier tape. A
cover tape is sealed over the top of the entire length of the carrier tape. The reel is sealed in a moisture barrier, ESD bag,
which is placed in a cardboard shipping box. It is important to note that unused moisture sensitive parts need to be
resealed in the moisture barrier bag. If the reels exceed the exposure limit and need to be rebaked, most carrier tape and
shipping reels are not rated as bakeable at 125°C. If baking is required, devices may be baked according to section 4,
table 4-1, column 8 of Joint Industry Standard IPC/JEDEC J-STD-033A.
The following table provides useful information for carrier tape and reels used for shipping the devices described in this
document.
RFMD Part Number
RF5110GTR7
Reel
Diameter
Inch (mm)
7 (178)
Hub
Diameter
Inch (mm)
2.4 (61)
Width
(mm)
12
Pocket Pitch
(mm)
4
Feed
Single
Units per
Reel
2500
QFN (Carrier Tape Drawing with Part Orientation)
Notes:
1. All dimensions are in millimeters (mm).
2. Unless otherwise specified, all dimension tolerances per EIA-481.
Ao = 3.18 ± 0.10
Bo = 3.18 ± 0.10
F = 5.50 ± 0.05
Ko = 1.02 ± 0.10
P = 4.00 ± 0.10
W = 12.00 +0.30/-0.10
Sprocket holes toward
rear of reel
4.00 ± 0.10
2.00 ± 0.05
15 inch Trailer
Top View
Ø1.50±.10
1.75±0.10
15 inch Leader
Pin 1
Location
RF
Part Number
Trace Code
RF
Part Number
Trace Code
RF
Part Number
Trace Code
RF
Part Number
Trace Code
RF
Part Number
Trace Code
RF
Part Number
Trace Code
RF
Part Number
Trace Code
F
W
Bo
0.279
±.020
Ko
P
Ao
Rev A3 060814
2-17