|
HD404449 Datasheet, PDF (44/125 Pages) Hitachi Semiconductor – HD404449 SERIES | |||
|
◁ |
HD404449 Series
Input/Output
The MCU has 64 input/output pins (D0âD11, R00âRC3) and 2 input pins (D12, D13). The features are
described below.
⢠10 pins (D0âD9) are high-current input/output pins.
⢠The D12, D13, R00âR02, and R30âR53 input/output pins are multiplexed with peripheral function pins
such as for the timers or serial interface. For these pins, the peripheral function setting is done prior to
the D or R port setting. Therefore, when a peripheral function is selected for a pin, the pin function and
input/output selection are automatically switched according to the setting.
⢠Input or output selection for input/output pins and port or peripheral function selection for multiplexed
pins are set by software.
⢠Peripheral function output pins are CMOS output pins. Only the R43/SO1 and R53/SO2 pins can be set to
NMOS open-drain output by software.
⢠In stop mode, the MCU is reset, and therefore peripheral function selection is cancelled. Input/output
pins are in high-impedance state.
⢠Each input/output pin has a built-in pull-up MOS, which can be individually turned on or off by
software.
I/O buffer configuration is shown in figure 28, programmable I/O circuits are listed in table 23, and I/O pin
circuit types are shown in table 24.
Table 23 Programmable I/O Circuits
MIS3 (Bit 3 of MIS)
0
1
DCD, DCR
0
1
0
1
PDR
0
1
0
1
0
1
0
1
CMOS buffer PMOS
â
â
â
On
â
â
â
On
NMOS
â
â
On
â
â
â
On
â
Pull-up MOS
â
â
â
â
â
On
â
On
Note: â indicates off status.
42
|
▷ |