HD64F2134ATF20 Datasheet, PDF (34/39 Pages) Renesas Technology Corp – E6000 Emulator HS2148EPI61H Supplementary Information

5.2 Diagnostic Test Procedure Using the Test Program
Insert the CD-R (HS2148EPI61SR supplied with the E6000) into CD-ROM drive of the host
computer by pressing the Shift key, move the current directory to <Drive>:Â¥Diag with a command
prompt, and enter one of the following commands according to the PC interface board used to
initiate the test program:
1. ISA bus interface boad (HS6000EII01H)
>TM2148 –ISA (RET)
2. PCI bus interface boad (HS6000EIC01H, HS6000EIC02H)
>TM2148 –PCI (RET)
3. PCMCIA interface card (HS6000EIP01H)
>TM2148 –PCCD (RET)
Be sure to initiate the test program from <Drive>:Â¥Diag. Do not initiate it from a directory other
than <Drive>:¥Diag, such as <Drive>:¥Diag¥TM2148 –ISA (RET). If the test program is
initiated when the current directory is not <Drive>:Â¥Diag, the test program will not operate
correctly.
When –S is added to the command line such as >TM2148 –ISA –S (RET), steps 1 to 18 will be
repeatedly executed. To stop the execution, enter Q.
Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the
HDI installation wizard is automatically started.
2. <Drive> is a drive name for the CD-ROM drive.
3. Do not remove the CD-R from the CD-ROM drive during text program execution.
%