16C6NL Datasheet, PDF (3/70 Pages) Renesas Technology Corp – Renesas MCU

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NL, M16C/6NN)
1. Overview
Table 1.2 Functions and Specifications for M16C/6N Group (128-pin Version: M16C/6NN)
Item
Specification
CPU
Number of fundamental 91 instructions
instructions
Minimum instruction execution time 41.7ns (f(BCLK) = 24 MHz, 1/1 prescaler, without software wait)
Operating mode
Single-chip, memory expansion and microprocessor modes
Address space
1 Mbyte
Memory capacity
Refer to Table 1.3 Product Information
Peripheral Ports
Input/Output: 113 pins, Input: 1 pin
Function Multifunction timers
Timer A: 16 bits ✕ 5 channels
Timer B: 16 bits ✕ 6 channels
Three-phase motor control circuit
Serial interfaces
3 channels
Clock synchronous, UART, I²C-bus ⁽¹⁾, IEBus ⁽²⁾
4 channels
Clock synchronous
A/D converter
10-bit A/D converter: 1 circuit, 26 channels
D/A converter
8 bits ✕ 2 channels
DMAC
2 channels
CRC calculation circuit
CRC-CCITT
CAN module
1 channel with 2.0B specification
Watchdog timer
15 bits ✕ 1 channel (with prescaler)
Interrupts
Internal: 32 sources, External: 12 sources
Software: 4 sources, Priority levels: 7 levels
Clock generation circuits 4 circuits
• Main clock oscillation circuit (*)
• Sub clock oscillation circuit (*)
• On-chip oscillator
• PLL frequency synthesizer
(*) Equipped with on-chip feedback resistor
Oscillation-stopped detector Main clock oscillation stop and re-oscillation detection function
Electrical Supply voltage
VCC = 3.0 to 5.5 V
Characteristics
(f(BCLK) = 24 MHz, 1/1 prescaler, without software wait)
Consumption Mask ROM 19mA (f(BCLK) = 24 MHz, PLL operation, no division)
current
Flash memory 21mA (f(BCLK) = 24 MHz, PLL operation, no division)
Mask ROM 3µA (f(BCLK) = 32 kHz, Wait mode, Oscillation capacity Low)
Flash memory 0.8µA (Stop mode, Topr = 25°C)
Flash Memory Programming and erasure voltage 3.3 ± 0.3 V or 5.0 ± 0.5 V
Version
Programming and erasure endurance 100 times
I/O
I/O withstand voltage
5.0 V
Characteristics Output current
5m A
Operating Ambient Temperature
-40 to 85°C
Device Configuration
CMOS high-performance silicon gate
Package
128-pin molded-plastic LQFP
NOTES:
1. I²C-bus is a trademark of Koninklijke Philips Electronics N.V.
2. IEBus is a trademark of NEC Electronics Corporation.
Rev.2.10 Aug 25, 2006 page 3 of 67
REJ03B0061-0210