HYS72T64301HP Datasheet, PDF (24/42 Pages) Qimonda AG – 240-Pin Registered DDR2 SDRAM Modules

Internet Data Sheet
HYS72T64301HP–[3S/3.7]–A
Registered DDR2 SDRAM Modules
13) The t_HZ, t_RPST and t_LZ, t_RPRE parameters are referenced to a specific voltage level, which specify when the device output is no longer driving
(t_HZ, t_RPST), or begins driving (t_LZ, t_RPRE). t_HZ and t_LZ transitions occur in the same access time windows as valid data transitions.These
parameters are verified by design and characterization, but not subject to production test.
14) The Auto-Refresh command interval has be reduced to 3.9 µs when operating the DDR2 DRAM in a temperature range between 85 °C
and 95 °C.
15) 0 °C≤ T_CASE ≤ 85 °C
16) 85 °C < T_CASE ≤ 95 °C
17) A maximum of eight Auto-Refresh commands can be posted to any given DDR2 SDRAM device.
18) The t_RRD timing parameter depends on the page size of the DRAM organization. See Table 3 “Ordering Information for RoHS
Compliant Products” on Page 5.
19) The maximum limit for the t_WPST parameter is not a device limit. The device operates with a greater value for this parameter, but system
performance (bus turnaround) degrades accordingly.
20) WR must be programmed to fulfill the minimum requirement for the t_WR timing parameter, where WR_MIN[cycles] = t_WR(ns)/t_CK(ns) rounded
up to the next integer value. t_DAL = WR + (t_RP/t_CK). For each of the terms, if not already an integer, round to the next highest integer. t_CK
refers to the application clock period. WR refers to the WR parameter stored in the MRS.
21) Minimum t_WTR is two clocks when operating the DDR2-SDRAM at frequencies ≤ 200 ΜΗz.
22) User can choose two different active power-down modes for additional power saving via MRS address bit A12. In “standard active power-
down mode” (MR, A12 = “0”) a fast power-down exit timing t_XARD can be used. In “low active power-down mode” (MR, A12 =”1”) a slow
power-down exit timing t_XARDS has to be satisfied.
Rev. 1.0, 2006-10
24
09152006-R5MQ-5KS2