WC701 Datasheet, PDF (5/28 Pages) Pulse A Technitrol Company – RF Chip Inductors

Wire-wound rf chip inductors
Performance testing
Electrical Testing
Storage and Operating
Temperature Range:
-40� to +125�C
Inductors are subjected to the
extremes for 48 hours.
Then tested at 25�C
Thermal:
-40� to +85�C
Moisture Resistance
Operating Life
Inductors are subjected to 30 cycles
for 30 minutes at each extreme.
Then tested at 25�C
Inductors are subjected to
10 cycles of 24 hours at 70�C with
90 to 95% Relative Humidity
Then tested at 25�C
Inductors are subjected to
1000 hours at 85C with 85%
Relative Humidity with
the rated current applied
Mechanical Testing
Temperature Range:
Inductors are subjected to the following:
Use a solder pot at 260C, with RMA Flux. Each
termination is immersed in 63Sn/37Pb molten solder
for 4 to 6 seconds.
There shall be no deformation
or change in appearance
Inductance shall not change
by more than ±5%
Q values shall not change
by more than ±10%
There shall be no Damaged,
Open or Shorted Windings
There shall be no deformation
or change in appearance
Inductance shall not change
by more than ±5%
Q values shall not change
by more than ±10%
Recommended Solder
Heat Resistance Profile
4
www.pulseelectronics.com
Pulse Jack
WC701.O (01/15)
Electronics