YR40.245 Datasheet, PDF (11/18 Pages) PULS GmbH – SINGLE REDUNDANCY MODULE

Y-Series
YR40.245
12-28V, 40A, SINGLE REDUNDANCY MODULE
11. ENVIRONMENT
Operational temperature ^*) -40°C to +70°C (-40°F to 158°F)
Storage temperature
-40 to +85°C (-40°F to 185°F)
for storage and transportation
Output de-rating
1A / °C
60-70°C (140°F to 158°F)
Humidity ^**)
5 to 95% r.H.
IEC 60068-2-30
Vibration sinusoidal ^***)
2-17.8Hz: ±1.6mm; 17.8-500Hz: 2g
2 hours / axis
IEC 60068-2-6
Shock ^***)
30g 6ms, 20g 11ms
IEC 60068-2-27
3 bumps / direction, 18 bumps in total
Altitude
0 to 2000m (0 to 6 560ft)
without any restrictions
2000 to 6000m (6 560 to 20 000ft)
reduce output power or ambient temperature,
see Fig. 11-2
Altitude de-rating
2.5A/1000m or 5°C/1000m
> 2000m (6500ft), see Fig. 11-2
Over-voltage category
not applicable
The concept of the overvoltage category is
used for equipment energized directly from
the low voltage mains (IEC 60664-1 §4.3.3.2.1).
Degree of pollution
2
IEC 62103, EN 50178, not conductive
LABS compatibility
The unit does not release any silicone or other LABS-critical substances and is suitable for
use in paint shops.
*) Operational temperature is the same as the ambient temperature and is defined as the air temperature 2cm below the unit.
**) Do not energize while condensation is present
***) Tested in combination with DIN-Rails according to EN 60715 with a height of 15mm and a thickness of 1.3mm and standard mounting
orientation.
Fig. 11-1 Output current vs. ambient temp.
Allowed Output Current
65A
short term (< 5s)
50
40
normal mode
30
20
10
0
-40 -25
Ambient Temperature
0 20
40 60 70°C
Fig. 11-2 Output current vs. altitude
Allowed Output Current
65A
short term (< 5s)
50
40
normal mode
C
B
30
A
20
10
0
0
A... Tamb < 70°C
B... Tamb < 60°C
C... Tamb < 50°C
2000
Altitude
4000
6000m
Apr. 2014 / Rev. 1.1 DS-YR40.245-EN
All parameters are specified at 24V, 40A output current, 25°C ambient and after a 5 minutes run-in time unless otherwise noted
www.pulspower.com Phone [phone] Germany
11/18