PT6332 Datasheet, PDF (37/37 Pages) Princeton Technology Corp – VFD Driver/Controller IC

VFD Driver/Controller IC
Tel: [phone]
Fax: [phone]
URL: http://www.princeton.com.tw
PT6332
Symbol
A
A1
A2
b
D
D1
e
E
E1
S
R1
R2
L
L1
C
θ
θ1
θ2
θ3
ccc
Min.
-
0.05
1.35
0.17
0.20
0.08
0.08
0.45
0.09
0°
0°
11°
11°
Nom.
-
-
1.40
0.22
14.00 BSC.
12.00 BSC.
0.50 BSC.
14.00 BSC.
12.00 BSC.
-
-
-
0.60
1.00 REF.
-
3.5°
-
12°
12°
0.08
Max.
1.60
0.15
1.45
0.27
-
-
0.20
0.75
0.20
7°
-
13°
13°
Notes:
1. Dimensioning and tolerancing per ASME Y14.5M-1994.
2. The top package body may be smaller than the bottom package size as much as 0.15mm.
3. Datum A-B and D to be determined at the datum plane H.
4. Dimensions D1 and E1 do not include mold protrusions. Allowable protrusion is 0.25mm per side.
d1 and E1 are maximum plastic body size dimensions including mold mismatch.
5. Controlling Dimensions: Millimeters
6. Dimension b does not include dambar protrusion. Allowable dambar protrusion shall not cause the
lead width to exceed the maximum b dimension by more than 0.08mm. Dambar cannot be located
on the lower radius or the foot. Minimum space between protrusion and an adjacent lead is 0.07 mm
for 0.4mm and 0.5mm pitch package.
7. A1 is defined as the distance from the seating plane to the lowest point on the package body.
8. Refer to JEDEC MS-026 Variation BDD.
JEDEC is the trademark of JEDEC SOLID STATE TECHNOLOGY CORPORAITON.
PT6332 V1.0
- 37 -
February, 2006